EasyManuals Logo

Uniden BCD436HP Owner's Manual

Uniden BCD436HP
104 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #49 background imageLoading...
Page #49 background image
41
At Confirm?, press E/yes or ./no.
Nothing Avoided appears if nothing is Avoided.
Set Audio AGCThis allows you to turn AGC (Automatic Gain Control) on or off for the System.
The default settings are Off.
Analog - Press E/yes to toggle On or Off.
Digital - Press E/yes to toggle On or Off.
P25 NAC Option (P25 One Freq) – This allows you to have the scanner search for NAC codes or
you can program a specic code for the System.
The default setting is Search.
Search. The scanner opens squelch for any digital signal and displays the NAC being used.
Set P25 NAC. The scanner opens squelch only for signals that include the programmed
NAC.
At Input P25 NAC, see Data Naming.
P25 Waiting Time (Conventional Only) – This setting gives the scanner time to determine
if channels on Conventional Systems have digital or analog transmissions. During this time,
the scanner will evaluate the received signal and, if it detects digital data, will open squelch
immediately. If digital is not detected before the delay expires, the scanner will open squelch at the
end of this delay. This is to prevent “false decode” problems. This setting only affects conventional
channels with an Audio Type set to All. The default setting is 400 ms.
0 to 1000
Note: Any analog transmissions will lose the rst part of the transmission, up to the wait
time you set here.
P25 Threshold Mode – (Conventional Only)
The default setting is Auto.
Auto. Automatically sets the decode threshold based on the received signal.
Manual. Allows you to manually set the threshold in threshold setting mode by using the P25
Threshold Level setting.
Default. Sets the scanner to the default threshold of 8, Auto.
P25 Threshold Level (Conventional Only) – The default setting is 8.
0 to 20
PROGRAMMING SITES
NEW SITE/SITE OPTIONS
Press Menu then scroll to Manage Favorites and press E/yes.
Scroll to the Favorites List and press E/yes.
Scroll to Review/Edit System and press E/yes.
Scroll to the System and press E/yes.
Scroll to Edit Site and press E/yes.
To Create a New Site, scroll to New Site and press E/yes.
To Edit an Existing Site, scroll to the Site and press E/yes.
Note: Not all options will appear for all sites.

Table of Contents

Other manuals for Uniden BCD436HP

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Uniden BCD436HP and is the answer not in the manual?

Uniden BCD436HP Specifications

General IconGeneral
ModelBCD436HP
AntennaRemovable SMA Antenna
Close Call RF CaptureYes
Dynamic MemoryYes
PC ProgrammableYes
Water ResistanceNo
CategoryScanner Radio
DisplayDot-matrix LCD
Power Source3x AA batteries or USB power
Weight10.1 oz
TypeHandheld
GPSOptional GPS receiver supported
Audio OutputEarphone jack (3.5 mm)
Trunking Systems SupportedMotorola, EDACS, LTR, APCO 25 Phase I and Phase II
Modulation TypesAM, FM, NFM, P25
Battery LifeVaries with usage
Display TypeLCD
USB PortYes
SD Card SlotYes
Frequency Range25-512 MHz, 758-960 MHz, 1240-1300 MHz

Related product manuals