EasyManuals Logo

Uniden BCD436HP Owner's Manual

Uniden BCD436HP
104 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #33 background imageLoading...
Page #33 background image
25
information included, the range setting will have no effect on them because the scanner
doesn’t know where they are.
2. You will receive Departments/Sites that have a range equal to your scan range setting plus
the programmed range of the Departments and Sites. For example, if your scan range is set
to 10 miles and a Department/Site range is set to 30 miles, and that Department/Site is less
than 40 miles away from your current location setting, it will be enabled in your Favorites List
according to both range settings.
3. If you use Add Current dB Channels from a list with a 10 mile range (selected location by
zip/postal code) and then set the range to 20 miles, Location Control will not add the other
channels included that extra 10 mile range.
EDIT LOCATION
This allows you to create a location or edit a location for rapid recall.
New Location or Edit Location
Edit Name. See Data Naming.
Use Location. This will set the location as current for scanning the Database and
Favorites Lists with Location Control enabled.
At Conrm? Press E/yes or ./no.
Delete Location. You can only delete saved locations. The last location set will be
retained for use when scanning the Database.
At Confirm Delete?, press E/yes or ./no.
Set Location Information. See Set Manual Location.
Set Range. Enter the range (0-50) and press E/yes.
Save Location – This will save the current location, the range, and set the location as current for
scanning the Database and Favorites Lists with Location Control enabled.
See Data Naming to name the location.
SELECTING SERVICE TYPES
Not all service types are enabled when you set your location in the scanner. By default only EMS
Dispatch, Fire Dispatch, Law Dispatch, Custom 1, and Multi-Dispatch are enabled.
The Appendix has a list of Service Types and their general descriptions.
(BCD536HP) Press the Serv button.
(BCD436HP) Press Func then the Zip/Services button.
Scroll to each Service Type and press E/yes to enable or disable.
Press System to exit.
When the scanner displays a Service Type that is not in the Favorite Lists, the scanner will display
a “---” indication.

Table of Contents

Other manuals for Uniden BCD436HP

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Uniden BCD436HP and is the answer not in the manual?

Uniden BCD436HP Specifications

General IconGeneral
ModelBCD436HP
AntennaRemovable SMA Antenna
Close Call RF CaptureYes
Dynamic MemoryYes
PC ProgrammableYes
Water ResistanceNo
CategoryScanner Radio
DisplayDot-matrix LCD
Power Source3x AA batteries or USB power
Weight10.1 oz
TypeHandheld
GPSOptional GPS receiver supported
Audio OutputEarphone jack (3.5 mm)
Trunking Systems SupportedMotorola, EDACS, LTR, APCO 25 Phase I and Phase II
Modulation TypesAM, FM, NFM, P25
Battery LifeVaries with usage
Display TypeLCD
USB PortYes
SD Card SlotYes
Frequency Range25-512 MHz, 758-960 MHz, 1240-1300 MHz

Related product manuals