Uniden BCD436HP Owner's Manual

54
TOGGLE ID SCAN OR ID SEARCH
While scanning each Trunked System, press Func then E/yes.
SELECT SERVICE TYPES
(BCD536HP) Press Serv.
(BCD436HP) Press Func then Zip/Services.
Scroll to each Service Type and press E/yes to enable or disable.
HOLDING
Channel Hold
Press Channel to hold on a Channel. Scroll to channels.
Press Channel to release Hold mode.
Department Hold
Press Dept to pause then hold on any Department.
Double press Dept to hold without a pause.
Press Dept then quickly scroll to the Department in pause mode.
Double press Dept to release Department hold.
Site Hold
Press Func then Dept to hold on any Site.
Press Func then Dept to release Site hold.
Press Dept then rotate the scroll control to select a Site.
System Hold
Press System to pause then hold on any System.
Double press System to hold without a pause.
Press System then quickly scroll to the System in pause mode.
Double press System to release System hold.
REPLAY THE LAST TRANSMISSIONS
While scanning, press Replay.
Press Channel to pause/resume replay.
Turn the Scroll Control to select recordings.
3-Line Display On

Uniden BCD436HP Specifications

General

Model	BCD436HP
Antenna	Removable SMA Antenna
Close Call RF Capture	Yes
Dynamic Memory	Yes
PC Programmable	Yes
Water Resistance	No
Category	Scanner Radio
Display	Dot-matrix LCD
Power Source	3x AA batteries or USB power
Weight	10.1 oz
Type	Handheld
GPS	Optional GPS receiver supported
Audio Output	Earphone jack (3.5 mm)
Trunking Systems Supported	Motorola, EDACS, LTR, APCO 25 Phase I and Phase II
Modulation Types	AM, FM, NFM, P25
Battery Life	Varies with usage
Display Type	LCD
USB Port	Yes
SD Card Slot	Yes
Frequency Range	25-512 MHz, 758-960 MHz, 1240-1300 MHz