EasyManuals Logo

Uniden BCD436HP Owner's Manual

Uniden BCD436HP
104 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #34 background imageLoading...
Page #34 background image
26
NAVIGATING THE MENUS
The Menu key lets you select options to set up and use the scanner. To select a menu item, rotate
the scroll control. Rotate right for down and left for up.
The currently-selected menu item is highlighted and reversed in the display. When the menu item
you want to select is highlighted, press E/yes or the scroll control to select it. To back up a level,
press Menu.
To exit all menus and return to the previous mode, press Avoid.
DATA NAMING
Name any Favorites List, System, Site, Department, Channel, Location, Custom Search,
Recording Session, Tone-Out, or SAME group using up to 64 characters.
To Enter a Character, turn the scroll control until the character you want appears.
To move the cursor to the right, press 6>.
To move the cursor to the left, press <4.
To clear a character, press ./no.
To clear all characters, press ./no twice.
Press E/yes when nished to exit.
DISPLAY MENU
Press Menu and then scroll to Display Options and press E/yes.
Scroll to the options below and press E/yes.
Set Backlight Set ID Format (MOT/P25)
Adjust Contrast Set ID Format (EDCS)
Disp. Unit ID Set Upside-Down (BCD536HP Only)
Setting the Backlight – The scanner will turn on/off the LCD and the Keypad backlight
automatically according to backlight setting.
Set Mode
Note: (BCD536HP Only) Keypress and Squelch settings will work only when the backlight
is Off.
Squelch
Off - The backlight stays off when the squelch opens.
5 sec - The backlight stays on 5 seconds after the squelch opens.
10 sec - The backlight stays on 10 seconds after the squelch opens.
Open Squelch - The backlight stays on only when the squelch is open.
Keypress
Off - The backlight stays off when any key is pressed.
5 sec - The backlight stays on for 5 seconds when any key is pressed.
10 sec - The backlight stays on for 10 seconds when any key is pressed.
Timeout (BCD436HP Only)

Table of Contents

Other manuals for Uniden BCD436HP

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Uniden BCD436HP and is the answer not in the manual?

Uniden BCD436HP Specifications

General IconGeneral
ModelBCD436HP
AntennaRemovable SMA Antenna
Close Call RF CaptureYes
Dynamic MemoryYes
PC ProgrammableYes
Water ResistanceNo
CategoryScanner Radio
DisplayDot-matrix LCD
Power Source3x AA batteries or USB power
Weight10.1 oz
TypeHandheld
GPSOptional GPS receiver supported
Audio OutputEarphone jack (3.5 mm)
Trunking Systems SupportedMotorola, EDACS, LTR, APCO 25 Phase I and Phase II
Modulation TypesAM, FM, NFM, P25
Battery LifeVaries with usage
Display TypeLCD
USB PortYes
SD Card SlotYes
Frequency Range25-512 MHz, 758-960 MHz, 1240-1300 MHz

Related product manuals