Uniden BCD436HP Owner's Manual

29
Displays to show Function mode.
F0-9 Indicates the first digit of the Favorites List quick key on the left with the blinking
second digit on the right in Scan mode.
A non-blinking number on the right indicates the quick key is enabled waiting to be
scanned.
A - (dash) means nothing is assign to the quick key.
An * (asterisk) means the quick key is disabled.
SITE HOLD Displays in Site Hold mode.
SEARCH Displays in Search mode.
Time Displays the time.
↑ or ↓ Displays to show the Scan or Search direction.
GPS Displays when connected to a GPS unit.
REC Displays when recording.
Displays to show Wi-Fi status is not connected. (BCD536HP Only)
Displays to show Wi-Fi status is connected. (BCD536HP Only)
AP Displays when connected in Access Point mode. (BCD536HP Only)
Displays to show the signal strength.
Displays in Priority mode.
Displays in reverse in Priority DND mode.
Displays and blinks if the battery is low. (BCD436HP Only)
Displays if the Close Call Priority feature is on.
Displays in reverse in Close Call DND mode.
S=NN Displays the squelch level for three seconds when you turn SQ.
Battery Level Displays when you press VOL. (BCD436HP Only)
Volume and Squelch

Uniden BCD436HP Specifications

General

Model	BCD436HP
Antenna	Removable SMA Antenna
Close Call RF Capture	Yes
Dynamic Memory	Yes
PC Programmable	Yes
Water Resistance	No
Category	Scanner Radio
Display	Dot-matrix LCD
Power Source	3x AA batteries or USB power
Weight	10.1 oz
Type	Handheld
GPS	Optional GPS receiver supported
Audio Output	Earphone jack (3.5 mm)
Trunking Systems Supported	Motorola, EDACS, LTR, APCO 25 Phase I and Phase II
Modulation Types	AM, FM, NFM, P25
Battery Life	Varies with usage
Display Type	LCD
USB Port	Yes
SD Card Slot	Yes
Frequency Range	25-512 MHz, 758-960 MHz, 1240-1300 MHz