EasyManuals Logo

Uniden BCD436HP Owner's Manual

Uniden BCD436HP
104 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #56 background imageLoading...
Page #56 background image
48
Set Number Tag – This allows you to number a Channel so you can access it quickly from scan
hold mode.
The default setting is no number tag. See also Using Number Tags.
0-999, Blank (No number tag)
Set Modulation (Conventional Only) – This setting selects the modulation used for the channel.
The default setting is Auto.
Auto, AM, FM, NFM, WFM, or FMB (FM Broadcast)
See also Scan Modulation.
Set Attenuator (Conventional Only) – This setting controls whether the scanner attenuates
signals on the Channel by about 20 dB.
The default setting is Off.
On or Off
See also Scan Attenuation.
Set Service Type – This sets the Service Type for The Channel.
The Appendix has a list of Service Types and their general descriptions.
Default is Custom 1.
Scroll to the Service Type and press E/yes.
Set Delay TimeThis sets (in seconds) the amount of time the scanner stays on a channel
after the transmission has ended before moving to the next channel. A negative delay will force a
resume after that number of seconds.
The default setting is 2 seconds.
-10, -5, 0, 1, 2, 3, 4, 5, 10, or 30 sec.
Set Priority – This sets the channel as a priority channel while scanning. The default setting is
Off.
Note: To use Priority ID Scan you must also enable Priority ID Scan for each System. See
also Priority Scanning.
On or Off
Set Alert – This setting controls when and how the scanner alerts you if the channel becomes
active. The default setting is Off.
Set Alert Tone
Alert 1-9 or Off.
Set Level
Level 1-15 or Auto (the master volume level).
Set Alert Light
Set Color
Off, Blue, Red, Magenta, Green, Cyan, Yellow, or White.
Set Pattern
On, Slow Blink, or Fast Blink.
Set AvoidThis determines whether a channel will be scanned or not. Temporary Avoids cancel
you cycle power. The default setting is Stop Avoiding.
Stop Avoiding, Temporary Avoid, or Permanent Avoid
See also Scan Avoids.
Volume Offset – This sets the Volume Offset for the Channel.

Table of Contents

Other manuals for Uniden BCD436HP

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Uniden BCD436HP and is the answer not in the manual?

Uniden BCD436HP Specifications

General IconGeneral
ModelBCD436HP
AntennaRemovable SMA Antenna
Close Call RF CaptureYes
Dynamic MemoryYes
PC ProgrammableYes
Water ResistanceNo
CategoryScanner Radio
DisplayDot-matrix LCD
Power Source3x AA batteries or USB power
Weight10.1 oz
TypeHandheld
GPSOptional GPS receiver supported
Audio OutputEarphone jack (3.5 mm)
Trunking Systems SupportedMotorola, EDACS, LTR, APCO 25 Phase I and Phase II
Modulation TypesAM, FM, NFM, P25
Battery LifeVaries with usage
Display TypeLCD
USB PortYes
SD Card SlotYes
Frequency Range25-512 MHz, 758-960 MHz, 1240-1300 MHz

Related product manuals