Name: Universal Audio Arrow
Brand: Universal Audio
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Arrow Manual Console Reference 125

When set to HP, the headphone output source is the dedicated HP cue mix, summed

with all DAW outputs that are routed to the HP outputs (if applicable).

In this mode, the mix of the HP cue bus is determined by the cue send controls in the

input channel strips and the aux return strips.

Console’s main monitor mix faders, mutes, and solos are not reﬂected in the headphone

output when HP is selected, because Console’s HP cue sends are always pre-fader.

Note: When HP is the selected cue source, signals must be sent to the HP cue

mix bus (via the HP cue sends) for the signal(s) to be heard in the headphone

outputs.

Cue Output Mono

This switch sums the left and right channels of the selected stereo source bus into a

monophonic signal. The headphone output is stereo when the switch is gray, and mono

when it is lit.

Tip: This switch only controls the headphone output. To hear the HP cue mix

in mono when it is routed to the monitor outputs (via the Control Room Source

switches), use the Monitor Mono switch instead.

Questions and Answers:

Need help?

Do you have a question about the Universal Audio Arrow and is the answer not in the manual?

Universal Audio Arrow Specifications

General