Arrow Manual Hardware Controls & Connectors 27
MONITOR Mode
When Arrow is in monitor mode, all top panel controls are related to output
functions only. To adjust any output function, press the MONITOR button to
enter monitor mode and activate the monitor controls.
Important: Arrow must be in MONITOR mode to adjust the volume of the
monitor and headphone outputs with the hardware controls. Monitor volume can be
adjusted with the Console software application when Arrow is not in monitor mode.
Stereo Outputs
Arrow has two stereo outputs that can be controlled with the top panel hardware:
MONITOR and HEADPHONE. These two stereo outputs are independently controlled.
Output Volume
The LEVEL knob is used to set the volume level for each stereo output independently.
The LEVEL knob adjusts the volume of the currently selected output only.
Output Selection
The currently selected output is shown by the MONITOR and
HEADPHONE indicators at the right of the main display, above and
below the output meters.
When in monitor mode, press the MONITOR button to change the
selected output. Press MONITOR again to switch back to the other
output.
Monitor Mute
When MONITOR is selected, press the LEVEL knob to mute (silence)
the stereo monitor outputs. Press the LEVEL knob again to unmute the
monitor outputs. The green level indicators (the ring of LEDs around the
LEVEL knob) and the monitor output selection indicator are RED when
the monitor outputs are muted.
LED ring showing monitor outputs unmuted (left) and muted (right)
Output selection
indicators
To Next Page
Loading...
Need help?
General
