Arrow Manual Working With Arrow 58
Routing DAW Outputs to Console Inputs
To route a DAW output signal into Console
for monitoring and/ Realtime UAD
Processing, assign any Console virtual
channel (or channel pair, when the DAW
source is stereo) as the output device for
any DAW track, bus, or output.
That DAW output signal then appears in
the associated virtual input channel(s) in
Console, and it can be processed or routed
the same as Arrow’s hardware inputs.
At Right: A stereo DAW channel’s outputs
assigned to Console’s virtual inputs
Routing Console Outputs to DAW Inputs
To route a Console output signal into the DAW
so it can be recorded, assign any Console virtual
channel (or channel pair, when the Console
source is stereo) as the input source for any
DAW input.
That Console signal can then be recorded or
routed by the DAW as if it were a hardware
input.
Tip: This technique can be used to re-capture
and record (bounce) a software instrument
performance that was virtually routed from
the DAW into Console for Realtime UAD
Processing.
At right: Console’s virtual outputs assigned to a DAW
channel’s input. Note that any output listed here
(including Console’s stereo MON, HP, and AUX mix
buses) can be used for DAW input.
To Next Page
Loading...
Need help?
General
