Universal Audio Arrow User Manual

Arrow Manual Console Settings 162
Identify
Clicking the Identify switch will cause the currently selected unit’s front panel LEDs to
flash in a pattern. This feature is typically used with multi-unit systems to distinguish
units when making I/O connections.
Remove
In multi-unit configurations (when the device column contains more than one unit), if
a device is offline, the REMOVE switch replaces the IDENTIFY switch in the options
column.
Offline devices can be removed from the devices list. To remove an offline device,
select the unit in the DEVICES column, then click the REMOVE switch in the OPTIONS
column.
Note: If an expander unit is powered down or disconnected from the system, the
expander unit must be removed before the sample rate can be changed to 176.4
kHz or 192 kHz.

Universal Audio Arrow Specifications

General

Type	Audio Interface
Connectivity	Thunderbolt 3
Input Channels	2
Output Channels	2
Simultaneous I/O	2 x 4
Preamps	2
Phantom Power	Yes
A/D Resolution	24-bit/192 kHz
Analog Inputs	2 x XLR/TRS Combo
Headphones	1 x 1/4"
Thunderbolt Ports	1 x Thunderbolt 3
Power Supply	Bus powered
Software	UAD Software
Compatibility	Mac, Windows
Analog Outputs	2 x 1/4" TRS