Arrow Manual UAD Meter & Control Panel 202
Plug-In Latency
UAD plug-in latency in the DAW, in samples and milliseconds, is displayed here when
the DAW is running.
Note: These plug-in latency values are unrelated to UAD plug-ins used within
Console.
The displayed values are calculated from the current audio I/O buffer size and the
session sample rate when Extra Buffering is off. When Extra Buffering is on, the
displayed latency is the I/O buffer size plus 64 samples.
The displayed latency value does not reflect the lowered latency when LiveTrack Mode is
active in UAD plug-ins within a DAW.
Note: The displayed sample latency number does not include the extra samples
produced by UAD plug-ins with additional latency. For more detailed information
about the extra samples and latency, see Latency & Arrow.
Hardware Section
Detailed information about each active UAD device and its DSP is displayed in the
Hardware area. If several devices are installed, use the scroll bar to see the other devices
if they are out of view.
Hardware section as it appears with multiple UAD devices
Device Status
For each installed device, its status and a small hardware icon are displayed. When the
device displays Status: OK the hardware is operating properly. The total number of UAD
plug-ins loaded on each device is also displayed here.
To Next Page
Loading...
Need help?
General
