Universal Robots OEM Control Box - 5.2.1. Grounding

Ensure that there is enough space for cables and sufficient air circulation around the Control
Box. For information about the heat dissipation, see 7.2. Control Unit Heat Dissipation on
page18. The following illustration shows the airflow.
NOTICE
Insufficient airflow or warm air circulation can cause the OEM Control Box to
overheat and shut down.
5.2.1. Grounding
The OEM Control Box casing is electrically connected to the ground pin of the power source
connector. Any conductive mounting surface must also be connected to the ground.
Installation Guide 13 OEM Control Box
5. Mechanical Installation
Copyright © 2019 by UniversalRobotsA/S. All rights reserved.