Universal Robots UR5e - Page 233

Assignment
Description Assigns values to the variables. The variable value can be the result of
expressions created in the Expression Editor (see section 3.4.3.
Expression Editoron page171).
You can also request a variable value from an operator. When requesting a
value from an operator, it is possible to display an Operator Message to
validate input against common variable types.
If
Description If and If...Else statements change the robot’s behavior based on sensor
inputs or variable values.
NOTICE
If there are waypoints inside an If expression or inside a
Loop expression with the Check Expression Continuously
option, you can add a stopj() or a stopl() after the
expression to gently decelerate the robot arm. This is valid
for both If and Loop Commands (see section ).
UR5e 233 User Manual
Copyright © 2009–2023 by UniversalRobotsA/S. All rights reserved.