2. Operation Manual Page 10
Operation
E
MERGENCY
L
OWERING
WARNING
!
!
If the platform should fail to lower, NEVER climb down the elevating assembly.
Stand clear of the elevating assembly while operating the Emergency Lowering Valve Knob.
Figure 5: Emergency Lowering
The Emergency Lowering Valve Knob is located
beside the ladder at the rear of the machine.
1. Open the Emergency Lowering Valve by pulling and
holding the knob.
2. To close, release the knob. The platform will not
elevate if the Emergency Lowering Valve is open.
WARNING
!
!
Never tow faster than 0,3 m/sec. (1 ft./sec.).
A
FTER
U
SE
E
ACH
D
AY
1. Ensure that the platform is fully lowered.
2. Park the machine on a firm level surface, preferably under cover, secure against vandals, children and
unauthorized operation.
3. Turn the Chassis Key Switch to OFF and remove the key to prevent unauthorized operation.
H
OUR
M
ETER
To access the hour meter function perform the following steps.
1. Climb into the basket (with the machine powered up)
2. Push the platform emergency stop button.
3. Hold down the following buttons, Horn and Lift.
4. While holding the buttons twist the emergency stop button to return power to the machine.
5. “hr” will now be displayed on the read-out, Pressing the right turn button will scroll through the
accumulated hours two digits at a time. For example, if pressing the right turn button once displays “20”,
pressing it a 2nd time displays “58”, and pressing it a 3rd time displays “hr”, the elapsed time of operation
is 2058 hours.
Emergency
Lowering
Valve Knob
To Next Page
Loading...
Need help?
General
