OPERATING MANUAL_______________________________________________________________
40_____________________________________________________________________M210492EN-A
• Select Scale. The quantity and scaling for channel 1 are displayed:
• If the settings are correct, press ENT.
• If the settings need to be changed, press CL:
− the quantity starts flashing; it can be changed with the arrow
keys and acknowledged with the ENT key
− the lower limit starts flashing
− acknowledge the lower limit with ENT or start changing it by
pressing CL; a new lower limit is given with the arrow keys
− the upper limit starts flashing
− acknowledge the upper limit with ENT or start changing it by
pressing CL; a new upper limit is given with the arrow keys
− When channel 1 has been set, the programme goes on to
channel 2; the procedure is the same as with channel 1.
Output via serial bus
Turning the serial interface echo ON/OFF
Select More in the main menu, select More in the More menu, then
again More and then Echo.
• Use the arrow keys to select the right alternative and press ENT.
Serial bus settings
• Select Seri in the main menu; the currently valid serial interface
settings are displayed:
To Next Page
Loading...
