Vaisala DMP248 - Setting the date; Setting the time

APPENDIX 1 SERIAL COMMANDS __________________________________________________________
94_____________________________________________________________________M210492EN-A
metric units non-metric units
Td °C °F
T
°C °F
RH %RH %RH
For example, the command for setting the non-metric units is:
>UNIT N <cr>
Output units : non metric
When the command is given with no parameters, the transmitter outputs the
currently valid setting.
ADDR Setting the transmitter address
ADDR aa <cr>
aa = address (0...99)
The address is used when more than one transmitter is connected to one serial
bus. The ADDR command makes it possible to communicate with one
transmitter at a time in POLL state.
For example, transmitter is given address 99
>ADDR <cr>
Address : 2 ? 99 <cr>
When asking the current address, no address number is given:
>ADDR <cr>
Address : 2 ? <cr>
RESET Resetting the transmitter
RESET <cr>
Resets the transmitter. All settings that have been changed stay in the memory
even after reset or power failure.