USER'S GUIDE ____________________________________________________________________
60 __________________________________________________________________ M210543EN-F
MES
After opening the line for operator commands (see section Entering and
Exiting Command Mode on page 51), use the MES command to display
a data message. See section Message Types on page 52 for message type
descriptions.
The command format is the following:
MES Message_number
The valid range is 0 ... 7.
For example, to choose the data message number 0, type the following:
>MES 0
AMES
The AMES command defines the message, which PWD22/52 transmits
as the automatic message or as the default polled message. See section
Automatic Message Sending on page 56.
Weather Related Commands
Use the following commands to display/set the weather analysis
parameters and results.
Weather parameter message
To Next Page
Loading...
