2. Press the right button marked 0Q0 and hold it for a maximum of 5 seconds before the electric starter starts the engine
87
,
then release the button.
1%&1&@J"&1!
1."@
3.4.2.1.2 MECHANICAL CHOKE ENGINE
1. Shift the accelerator lever in
"!Y
. into N ZHposition.
%&1""%%-N,]!
2. Start the engine by pulling the manual starter cord
88
.
3. Let the new or cold engine run for about 30 seconds on the choke (accelerator lever in position O ZH), then move the
accelerator lever to position N,].
1."@
3.4.2.1.3 AUTOMATIC CHOKE ENGINE
1. Shift the accelerator lever in
"!Y
. into N ,]position.
2. Start the engine by pulling the manual starter cord
89
!
3. The automatic choke adjusts the speed setting itself when the engine warms up
90
.
1."@
3.4.2.2 STARTING UP THE CUTTING DISC
,%%-;%&"%&.&"."@*.1;&
"1"1@
1. Start the engine
91
. If the engine is cold, allow it to warm up at maximum speed for about 1 minute.
2. Take hold of the handlebars handle with your left hand. With your right hand then slowly push the lever (LV in
"!M
) on the
right handle.
%%1-%-&%;-"&"&-.
..!
3. After starting up the cutting disc, press the lever to the handle and hold firmly.
0"&":-""-&13:%"-&&.."<";%=!0
.."%%1&--3:%:!
)
During the first starts of the cutting disc, a new or cold engine might stall. This tendency disappears after warming up the engine. In
case the cutting disc drive cannot be runned up, check if there is a defect according to
0%LR.
3.4.2.3 PUTTING THE MACHINE IN MOTION
To put the machine in motion use lever LS in
"!O
on the left handle. Press the lever all the way to the handle, and the machine
moves ahead immediately. Adjust the speed of your walk to machine speed as soon as you press the lever and the machine moves.
The wheel drive has a belt clutch; you can press the lever slowly and the machine starts off fluently, not with a jump.
%1-"%"%%%1&&%!*.%-&--%1;"
&3:%!
0%&"%"%&&'%%-&@
%&"%"-&@
3.4.2.4 MACHINE STOPPING
If you wish to stop the machine, release the left handlebar lever. The machine stops moving, but the cutting disk spins. The cutting disc
drive is turned off by releasing the right handlebar lever. The cutting disc is stopped by an automatic brake. Shift the accelerator lever into
,* or 0H position. To switch off the engine on machines equipped with a start panel
"!W
, press the left button 0H.
%1"..&."&-.1"1"@
%1"...%"@
%a-&.%&%%"%"
."%&&&%&&..@0"&-"%&&&<3:%;
%-%%1;"%"-%%1;"!=@
YS
Wait at least 10 seconds between start cycles.
YY
Instructions for starting the engine are described in detail in the engine operating instructions.
YW
Instructions for starting the engine are described in detail in the engine operating instructions.
WR
Depending on the ambient temperature and the engine temperature, the automatic choke is activated for approx. 1 minute.
WL
Differences in starting the engine are described in chapter 3.4.2.1.
NY
Q#RSMRML
To Next Page
Loading...
