3.4.3 WORK WITH THE MACHINE
3.4.3.1 CUTTING WIDTH
%1&'"&&&1@
We recommend to use the cutter partially (approximately 5-10 cm from the edge of the front cover) in the cut stand (as shown in
"!LL
from the user’s point of view).
3.4.3.2 METHODS OF STAND CUTTING
Q1%&-.&."<";;%""%.;"!=;
"%&1&"!*."&;&!
It is necessary to keep the lower disc sliding across the land without bouncing off when cutting in uneven terrain. Disc bouncing causes
low quality stand cutting and uneven stubble.
Let the engine and cutting disc spin in their maximum rpm, and start moving against the stand you wish to cut. The cutting disc throws
cut stand onto the right side, where it is windrowed by the side screen.
Always keep the cut brush on the left side form the machine when cutting (
"!LL
).
The cover is designed so that the mowed vegetation leaves smoothly when using full cutting width.
C"%-%%-"%!Keep the safe climbing ability (
0%O
)!
In case the cut stand is too dense, inter grown, rotten, or flattened, it is necessary to adjust the machine cutting width, so that the
cutting disc rpm would not be too low, and thus causing low cutting quality.
3.4.3.2.1 CUTTING PROBLEMS
-"%%1".%%.&"@
%1.."%-"&-"@
%1-""&&%%1!%1-"%%1".%-"
&%.&"!"".-@
%1-"%%1".%"%-"&-"!0"%&-![
%;"'";!!-".";."%"!
."1"1"&;%1%"&"-!
L! 0"&"&-%&;&%%!
Stop the machine immediately, reverse slightly while lifting the front of the machine a bit (by pressing the handlebars
down). The space under the top cover partially cleans itself from extensive amounts of grass mass. Start moving against
the stand again.
M! &--&-;%&!
Release both handlebars levers and lift the cutter by pressing the handlebars. Move the cutter slightly backwards. Clean
the space under the top cover, and spread the cut grass across the surface. Start the engine, turn the cutting disc drive
on, and start moving against the stand again.
N! 0"-""&"(because the stand is too thick).
Stop the cutter and turn the engine off. Dismount the side screen and put it in a safe place, out of the cut area, so that it
cannot be stolen.
3.5 MAINTENANCE, SERVICING AND STORAGE
0."h-."1"&&'!
In order to be happy with our product in the long-term, it is necessary to give it adequate maintenance and servicing care. Regular
maintenance reduces deterioration and ensures proper functioning.
Follow all instructions concerning maintenance and adjustment schedule. It is recommended that you keep a record of the amount of its
working time and conditions (for service needs). It is recommended to let one of our authorised service centres take care of the after-
season maintenance, as well as regular maintenance if you are not sure about your technical skills.
"--&"%&&%&".%."
"!
3.5.1 TRAVELLING WHEELS
Travelling wheels create an important part of the cutter. Wheels carry the whole weight of the cutter, transfer engine power, and push
the cutter into mesh.
3.5.1.1 TYRE PRESSURE
Tyre pressure has to be controlled in order to secure proper functioning and long life of the wheels, especially the tyres. Check the
pressure before you start using the cutter. Fill the pressure to ,] before putting the cutter out of service for a longer period of time. Keep
equal pressure in right and left wheels - it helps the cutter to keep a straight track.
NW
Q#RSMRML
To Next Page
Loading...
