Vari Agatha - Picture Appendix


3.7 PICTURE APPENDIX
The picture appendix is common for all the language versions.
0%."-.-""-P H#1H#1"Q1-VR
"L : Unpacking the machine
"M : Main parts of the machine
"N : Safety pictograph – Combinied sticker Location on the machine
"O : Safety pictograph –
Roztočení disku Location on the machine
"P : Safety pictograph –
Machine wheel drive Location on the machine
"V : Safety pictograph – Rotation direction arrow
Location on the machine "S : Safety pictograph – Dangerous area
LSTOP position
Engine not running.
 Used to switch off the
started engine.
 Putting the machine out
of service.
 Refuelling.
 Machine transport.
"Y : Accelerator lever positions
N MAX position
Engine running at maximum rpm.
(hare sign)
 Working position
M MIN position
Engine running at idle. (turtle
sign)
 Short work break.
O CHOKE position
Engine running at choke.
 Cold engine start.
It is not used for engines with an
automatic choke.
"W : Start panel
")
0H - Switching off the running engine. (Ignition coil shorted..)
L - Starting circuit connected.
)
0Q0 - Starting the engine %1 with the switch in position
L.
 "-
0H.
"LR : Machine assembly procedure
"LL : Cutting width "LM : Lubricating point "LN : Lubricating point
"LO : Lubricating point "LP : Lubricating point "LV : Replacement of blades
"LS : Removing the rear covers "LY : Cables adjustment "LW : Cables connection
"MR : V-belt track
OP
Q#RSMRML