22
Recalling a preset
There are a total of 24 preset positions (6 FM1,
6 FM2, 6 FM3, 6 AM) for storing individual
radio stations. The stored radio frequency is
automatically recalled by actuating the corre-
sponding preset button.
1. Actuate the BAND button e and set the
desired waveband. (FM or AM (MW/LW))
2. Actuate the corresponding preset button c
to recall the stored station.
* Press and hold the one of the preset buttons for at least
2 seconds to store the station in the preset memory.
Manual storage
1. Actuate the BAND button e and set the
desired waveband. (FM or AM (MW/LW))
2. Set the desired station by means of automatic
search, manual tuning or preset tuning.
3. Press and hold the one of the preset buttons
c for at least 2 seconds to store the currently
set station in the preset memory.
Radio operation
Automatic storage – AS
Up to 6 stations can be stored automatically
using the AS function button. If 6 receivable
stations cannot be set, the station previously
stored at this memory position is retained.
1. Actuate the BAND button e and set the
desired waveband. (FM or AM (MW/LW))
2. Press the AS/SCN button 5 for at least 2 sec-
onds. This automatically stores all stations
with a high signal strength.
* When automatic storage is performed for VHF wave-
bands, the stations are stored under FM3 even if FM1
or FM2 was previously selected.
Preset scan – SCN
The stations stored in the preset memory are
briefly scanned in sequence using the scan func-
tion. This function is particularly suitable for
locating a desired station in the memory.
1. Press the AS/SCN button 5.
2. As soon as the desired station is received,
press the AS/SCN button again to set the sta-
tion.
To Next Page
Loading...
