42
1. Loosen the special screw after the rear of
main unit has been secured according to the
procedure shown in Figure 6.
2. Remove the outer decorative moulding.
3. Insert the hooked plate between the spring
and the universal mounting frame, insert
tab B of the spring into hole A of the
hooked plate and pull out the main unit us-
ing the hooked plate. (Insert the right and
left edges of the hooked plate.) (Figure 7)
Note: Keep the hooked plates in a safe place.
The main unit cannot be removed unless
it is released using the hooked plates.
6. REMOVING THE MAIN UNIT
Figure 7
Spring
Universal mounting frame
2 hooked plates
Outer decorative moulding
Instrument panel
Main unit
To Next Page
Loading...
