VendCo KARISMA - Milk Parameters; Milk Dose, Capacity, and Emulsion; Unit Price and Display Arrangement; Hot Water and Steam Settings

© by N&W GLOBAL VENDING S.p.A. 32 07-2015 4535 00
milk parameterS
Only models with cappuccino maker
milk doSe
You can dene (in CC) the amount of milk to be used in
the preparation of the beverage.
milk capacity
You can dene (in CC/s) the capacity of milk to be used
in the preparation of the beverage.
This value is used to vary the temperature of the milk
milk emulSion
This parameter denes the volume of milk
in the cup (for example for the cappuccino selection)
This parameter is expressed in %.
A lower percentage indicates little foam in the cup.
cappuccino maker air timeS
The delay time of the emulsion with the air from the be-
ginning of the milk delivery can be set in seconds.
You can set, in seconds, how long before the dispensing
ends, to stop the emulsion with the air (coda)
cappuccino maker Steam timeS
The delay time of the steam delivery from the beginning
of the milk delivery can be set in seconds.
You can set, in seconds, how long before the dispensing
ends, to stop the emulsion with the air (coda)
unit price
This function is active only if the machine has a payment
module.
It sets the sale price of the drink; the default prices are
set to zero
arrangement on the diSplay
Allows you to change the position of the icons displayed
in normal use compared to the normal layout set.
The selection number you want to re-position is required
(see the supplied doses and selection table).
Pressing the conrmation button a screen appears with
the current arrangement of the icons; click on the desti-
nation icon to swap the two icons
hot water
It allows the user to:
- enable/disable the “Hot water” button
- set the time to deliver hot water from the spout
- set the productivity:
low: low water flow but high temperature
default: water flow automatically adjusted to maintain a
consistent temperature
high: high water flow but at low temperature )
Steam
Allows you to determine whether or not to activate the
“steam” button and the temperature control of the steam
released by the spout.
- OFF: Temperature control disabled, the heating of bev-
erages with the steam spout takes place for 2 minutes.
- ON: Temperature control enabled, the heating of drinks
with the steam spout is at the set temperature for a
maximum of 2 minutes
Set the temperature in °C