VendCo KARISMA - Fault Reset and Statistics; Fault Reset and History; Statistics Display and Reset; Boiler Temperatures

© by N&W GLOBAL VENDING S.p.A. 38 02-2014 4535 00
- Empty steam boiler
The machine does not make the selections based on
milk or does not release steam if the presence of water
in the steam boiler is not reported.
The boiler heating is inhibited.
If, after 30 minutes from start-up, or 10 minutes from
the last selection, the steam boiler has not reached the
temperature, the milk-based selections are locked.
- Pump fault 1...7
If the current absorption of a pump is not between the
range of default values, all the selections in which the
pump is involved are disabled.
- Faulty mixer 1...6 (whipper fault)
If the current absorption of a mixer motor is not be-
tween the range of default values, all the selections in
which that mixer is involved are disabled.
- Faulty pump 1...7 (pump fault)
If the current absorption of a pump is not between the
range of default values, all the selections in which that
pump is involved are disabled.
- Short circuit mosfet
If a control device for the DC motors on the activations
board (mosfet) remains active, the machine will signal
a fault.
- Low water pressure
the pressure switch measures low water pressure
inside the machine.
- Short circuit
If the software detects a short circuit in one of the DC
motors connected to the activations board, this fault will
be displayed. It is possible that at the same time of this,
a fault is also detected on one of the DC motors.
- Machine block
The machine shuts down if it reaches the number of
coffee and instant beverages selections set separately
with the “selection counter” function
- Coffee out of service
The machine shuts down if it reaches the number of
coffee selections set separately with the “selection
counter” function.
- Instant beverages out of service
The machine shuts down if it reaches the number of
coffee selections set separately with the “selection
counter” function.
fault rEsEt
By conrming the function, all the faults present in the
“latest faults list” are reset.
complEtE fault list (History)
It is possible to display the last 16 faults, from the most
recent to the oldest; the corresponding date and time of
intervention are also displayed and whether the fault is
still active or not (ON / OFF)
complEtE fault list rEsEt (History)
Conrm to reset all possible faults.
statistics
All the data related to the operation of the machine is
stored both in total counters and in relative counters,
which can be reset without losing the total data.
Display of rElativE statistics
By pressing the conrmation key

the partial data of
the faults stored by the counters are displayed in se-
quence:
Display of gENEral statistics
By pressing the conrmation key

the total data of the
faults stored by the counters are displayed in sequence
partial statistics rEsEt
By pressing the conrmation key

the partial data of
the faults stored by the counters are reset
Display of boilEr tEmpEraturEs
This function allows you to view the working temperature
(in °C) of the boiler.