Options We value your opinion
Ver-Mac 2018 V-Touch TLD User's Manual – V3.2 23
6.1.1 What You See
Buttons
New config enables admin users to configure TLD units
controlling the intersection so that the signalization system is set
up to operate effectively.
Maintenance allows a user to access and run certain tests on
the TLD to ensure that the TLD unit hardware is working
GPS permits users to check the intersection location and
positioning of the TLD.
Schedule allows you to Start and Stop schedules, as well as
Create or Edit a schedule. See its dedicated chapter 7 on
page 30 for a detailed description.
Edit Config enables an admin user to change certain settings
of the intersection setup and the default settings for the signals.
Devices allows you to see a list of all detected active peripheral
devices on the TLD.
Energy Thresholds is where you set your voltage level that you
consider as low level, fully charged and when to turn off the
Data Management lets you download action and step logs to a
USB drive.
Wireless Remote pairs wireless controllers with the TLD
system.
Table 4 Options buttons
6.2 New Configuration
All Ver-Mac TLD units leave the factory already configured for a specific traffic control
pattern and intersection type.
Normally you do not need to configure your system.
1. To access the New Configuration screen, tap in Options screen.
2. In each configuration screen select the feature you want to include in the
signalization setup for the intersection.
For full details on the system configuration for the intersection, please see Part 2 of
this manual.
To Next Page
Loading...
Need help?
General
