VeriFone VX 680 Installation Guide

TERMINAL SETUP
VX 680 Bluetooth
®
Support
VX 680 INSTALLATION GUIDE 27
Power Connection
to the Bluetooth
®
AP Charging Base
Station
The Bluetooth
®
AP Charging Base Station comes with a universal-input power
pack capable of operating from voltages of 100V-240V AC.
To Connect the Power
Pack
1 Insert the round barrel connector into the power port on the Bluetooth
®
AP
Charging Base Station, as shown in Figure 11.
Figure 11 Power Connection to the Bluetooth
®
AP Charging Base
Station
2 Insert the AC power cord into the power pack.
3 Plug the AC power cord into a wall outlet or powered surge protector.
4 Confirm that the Base Station is powered up as indicated by the solid green
LED.
WARNING
Do not plug the power pack into an outdoor outlet or operate the terminal
outdoors.
NOTE
To protect against possible damage caused by lightning strikes and electrical
surges, consider installing a power surge protector.

VeriFone VX 680 Specifications

General

Display	3.5” QVGA (320 x 240 pixels) color LCD with backlight
Connectivity	Wi-Fi, Bluetooth, Ethernet
Processor	400 MHz ARM11 processor
Memory	128 MB Flash, 64 MB SDRAM
Operating System	Verix
Card Readers	MSR, EMV smart card reader, contactless/NFC
Printer	Integrated thermal printer
SAM Slots	3 SAM slots
Peripheral Ports	RS-232 port, USB port
Power Supply	AC adapter (100-240V), Battery backup
Weight	500g