EasyManuals Logo

VeriFone VX 680 Installation Guide

VeriFone VX 680
66 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #40 background imageLoading...
Page #40 background image
TERMINAL SETUP
Charging the Smart Battery
40 VX 680 INSTALLATION GUIDE
Charging the
Smart Battery
After unpacking your VX 680 terminal, install the battery and connect the power
pack to the unit for 6 hours or until fully charged.
The smart battery has a safety circuit to protect the Li-ion cells from overcharging
and over-discharging. If the battery is over-discharged, the safety circuit shuts
down the battery. The battery must then be recharged to restore operation.
Battery Life
Charging and discharging the VX 680 smart battery hundreds of times will wear
out the battery. Significantly reduced operating times indicate the need for battery
replacement (see Accessories and Documentation for ordering information).
NOTE
The terminal charges the VX 680 smart battery when the terminal is in the Base
Station. For more information, see Mounting the Terminal Onto the Base Station.
NOTE
The VX 680 terminal automatically shuts off when the smart battery reaches the
critically low charge state. If this occurs, the smart battery must be recharged for a
minimum of 1/2 hour before it can power the terminal. It may take several
recharge attempts to reset the safety circuit when charging a smart battery that
has been discharged below this critical state.
WARNING
Do not dispose of batteries in a fire. Li-ion batteries must be recycled
or disposed of properly. Do not dispose of Li-ion batteries in municipal
waste sites.

Table of Contents

Other manuals for VeriFone VX 680

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the VeriFone VX 680 and is the answer not in the manual?

VeriFone VX 680 Specifications

General IconGeneral
Display3.5” QVGA (320 x 240 pixels) color LCD with backlight
ConnectivityWi-Fi, Bluetooth, Ethernet
Processor400 MHz ARM11 processor
Memory128 MB Flash, 64 MB SDRAM
Operating SystemVerix
Card ReadersMSR, EMV smart card reader, contactless/NFC
PrinterIntegrated thermal printer
SAM Slots3 SAM slots
Peripheral PortsRS-232 port, USB port
Power SupplyAC adapter (100-240V), Battery backup
Weight500g

Related product manuals