05 / CONFIGURING
ADVANCED SETTINGS
65
http://setup.verizon.com/businessinternetgateway |
©2024 Verizon. All Rights Reserved
• NDP (Neighbor Discovery Protocol) Table – displays active devices with their
IPv6 and MAC addresses of DHCP connection.
• Network Connections – displays and manages the details of a specific
network connection.
• Network Objects – defines a group, such as a group of computers.
• Port Configuration – sets up the Ethernet ports as either full- or half-duplex
ports, at either 10 Mbps, 100 Mbps, or 1000 Mbps.
• Routing – manages the routing and IP address distribution rules.
Diagnostics & Monitoring – performs diagnostic tests and displays the details and
status of:
• Bandwidth Monitoring
• System Logging
• Full Status/System wide Monitoring of Connections/Traffic Monitoring
• Backhaul Logging
Advanced System Settings
• Date & Time Settings – sets the time zone and enables automatic time
updates.
• Factory Reset – resets your Gateway to its default settings.
• LED Brightness – controls the Status LED light to either dim or brighten.
• Reboot Router – restarts your Gateway.
• Remote Administration - enables remote configuration of your Gateway from
any internet-accessible computer.
• System Settings – sets up various system and management parameters.
To Next Page