GETTING TO KNOW YOUR VERIZON
bUSINESS INTERNET GATEWAY
1.1 a/ RESET PIN hOLE
The reset PIN hole allows you to reset the gateway back to its factory
default state. Using the reset function will revert all settings and changes
made during the setup process. To perform a factory reset and return the
Verizon Business Internet Gateway to default settings, press and hold the reset
PIN hole for 3+ seconds. The System LED will flash yellow to indicate a reset has
been triggered, followed by fading in/out (white) while the gateway restarts.
1.1 b/ WPS
WPS is an easy way to add supported Wi-Fi devices to your network. Press
the WPS button on the back of the Gateway to activate WPS. You will need to
activate WPS on your Wi-Fi device too. Refer to “3.1d/ Wi-Fi Protected Setup
(WPS)” on page 40.
1.1 c/ LEDS
The LEDs indicate the system and connection status, and WPS activity.
System LED
LED Mode Status LED Pattern
System Status (
Power)
Bootup
System booting Soft blink white
Firmware update Fast blink white
Regular usage mode Rest mode Solid white
Wired WAN connectivity In service Solid blue
IP Passthrough mode
IPPT ( IP Passthrough)
enabled
Solid green
To Next Page
Loading...
