bASIC SETTINGS
2. To activate the Wi-Fi radio, move the selector to on. If the radio is not
enabled, no Wi-Fi devices will be able to connect to the office network.
3. If desired, enter a new name and password for the Wi-Fi network or
leave the default name and password that displays automatically.
Note: The SSID is the network name. All devices must use the same SSID.
4. To configure the Wi-Fi Security, click the setup button and select
WPA2 or WPA3.
Caution: These settings should only be configured by experienced network
technicians. Changing the settings could adversely affect the operation of
your Gateway and your local network.
• Broadcast Wi-Fi network name (SSID)
You can configure the Gateway’s SSID broadcast capabilities to allow or disallow
Wi-Fi devices from automatically using a broadcast SSID name to detect your
gateway Wi-Fi network.
– To enable SSID broadcasting, move the selector to on. SSID broadcast
is enabled by default. The SSID of the Wi-Fi network will be broadcast to
all Wi-Fi devices.
– To disable SSID broadcasting, move the selector to off. The public SSID
broadcast will be hidden from all Wi-Fi devices. You will need to manually
configure additional Wi-Fi devices to join the Wi-Fi network.
• MAC Authentication
You can configure your Gateway to limit access to your Wi-Fi network to only
those devices with specific MAC addresses.
To Next Page
Loading...
