Vertiv Avocent AutoView 2108 User Manual

NOTE: During an upgrade, the IQ module status indicator in the Main dialog box is yellow. The IQ
modules are unavailable when an upgrade is in progress. When an upgrade is initiated, any current
connection to the device using the IQ module is terminated.
To simultaneously upgrade multiple IQ modules:
1. Activate the OSCAR interface, click Commands - IQ Status and click one or more types of IQ
modules to upgrade.
2. Click Upgrade.
NOTE: When the Enable IQ Auto update option is enabled in the IQ Status dialog box, IQ module
firmware is automatically upgraded when the switch firmware is upgraded or when a new IQ module is
discovered by the switch after a firmware upgrade. IQmodules that have already been discovered but
are not attached to the switch during the firmware upgrade must be upgraded manually.
3. The IQ Upgrade dialog box is displayed. Click OK to initiate the upgrade and return to the IQ
Status dialog box.
To return an IQ module to factory default status:
1. Click IQ in the Version dialog box.
2. Select an IQ module, then click Decommission.
3. Click OK to restore factory defaults. You will see the IQ module go offline briefly and return.
- or-
Click X or press Escape to cancel the operation.
4. Click X to close the IQ Select dialog box.
Vertiv™ | Avocent® AutoView ™ Switch for Dell Installer/User Guide
28

Vertiv Avocent AutoView 2108 Specifications

General

Brand	Vertiv
Model	Avocent AutoView 2108
Category	Switch
Language	English