Maintenance
67
Service - check
Knives
Check the machine knives on a regular basis
The machine's knives must be regularly inspected.
Worn or damaged knives can unbalance the rotating parts.
Vibrations can cause damage on the machine.
The knives are checked in the following way:
→ »Maintenance intervals« Page 55.
> Remove the ring nut shown.
> Open the machine's first protection.
> Turn the cutting discs by hand until the damaged knife is in the po-
sition shown.
> Undertake an inspection of the bolts and knives for wear and tear.
• Additional knives can be stored in the compartment in the suspen-
sion.
→ »Synopsis« Page 19.
> Use a suitable wrench and tighten up the bolt to a torque of 95 Nm.
Ring nut
95 Nm +/- 5
To Next Page
Loading...
