3.2 Transport and Storage
The laser system is a precision-made instrument and includes numerous elec-
tronic and optical components. Please avoid any mechanical stress (shock, vibra-
tions, etc.) on the laser system. In case of questions concerning transport and
storage please contact Videojet Technologies Inc..
Transport
CAUTION
Switch off the laser system before transport and disconnect mains connection!
Please make sure that the supply line ("umbilical") connecting marking unit and
supply unit is not bent!
Do not use the umbilical to carry the laser system!
Wear safety shoes!
Storage
Store the laser system in a horizontal position protected against dust and humidi-
ty. Never expose the laser system or one of its components to direct sunlight! The
storage temperature must not exceed +65 °C.
The laser system has to be protected against frost, which means that the stor-
age temperature must not fall below 5 °C. The air humidity must be between
10 % to 90 %.
3.3 Unpacking
1. Open the packaging and remove the filling material.
2. Remove the individually packed components.
3. Check all parts for damage during transport.
In case of damage please inform the forwarding agent and Videojet Technolo-
gies Inc. or their representative immediately in writing. Keep the packaging
material and note damage on the inside and outside. Take pictures, if possi-
ble.
4. Transport the laser system and the components to the intended place of in-
stallation.
5. Protect the laser system and all components from dust and humidity until in-
stallation.
Protect the environment!
Separate packaging material for recycling.
09/17 - Index: AD [EN]
19
Videojet 3140/3340/3640/3 Installation
To Next Page
Loading...