3.9 Shutdown
3.9.1 Temporary Shutdown
If the laser system is shut down temporarily (e.g. for the duration of a works holi-
day), the following work is to be carried out:
1. Save the data on the computer before switching the laser system off. A de-
tailed description can be found in the manual of the marking software.
2. Switch the laser system off after the data backup, (see chapter »Operation of
the Laser System«).
3. Secure the laser system against unauthorized startup by removing the key
(key switch).
4. Clean the laser scan lens (see section »Cleaning the Laser Scan Lens).
3.9.2 Final Shutdown
WARNING
Ensure that all live parts are switched off and that work can be carried out safely
on these parts.
If the laser marking machine is shut down permanently (e.g. for selling or dispos-
al), the following work is to be carried out:
1. Carry out all work listed in section "Temporary Shutdown".
2. Disconnect the machine from the electric power supply.
In case of selling and transport
Package the machine according to the instructions in section "Transport and Stor‐
age [} 19]".
In case of disposal
Dispose of the components of the laser system in a manner that is safe and envi-
ronmentally compatible. Observe all applicable legal and local regulations.
Please dispose of the components of the laser system separated for recycling of
raw materials.
09/17 - Index: AD [EN]
24
Videojet 3140/3340/3640/3 Installation
To Next Page
Loading...