3.4 Installation Conditions
CAUTION
The laser system must not be subject to any mechanical stress (shock, vibrations,
etc.) since this reduces the marking quality and can result in damaging the sys-
tem.
Please consider upon installation that the supply line between supply unit and
marking unit is not designed for continuous alternating bending. Make sure that
no injuries can be caused by the installed supply line.
When installing the system the regulations of EN 60950-1 and EN 62368-1 must
be observed.
Space Required
The standard dimensions of the laser system can be found in the drawings in the
chapter "Appendix".
For systems manufactured according to special customer requirements this infor-
mation can be found in the installation plan or the dimension and data sheets you
received upon order handling.
Connections
The laser system requires a mains connection. Information on the type, number
and reference values of the connections can be found in the terminal diagrams
you have received upon order handling.
WARNING
Only the delivered power connection cable must be used!
Check the cable regularly for damage. If the cable is damaged it must be
changed immediately to avoid the risk of electrical shocks due to insufficient
grounding.
Since the power connection cable is mounted to the supply unit, the power socket
must be accessible and it must be possible to disconnect the mains connector
from the power socket. If necessary, an appropriate switching device must be in-
stalled.
The power connection cable of the laser system is about 4.5 m long, make sure
that the adequate power sockets are in range.
Ambient Conditions
Temperature range: 5 - 40 °C
Relative humidity: 10 - 90 %, non-condensing
09/17 - Index: AD [EN]
20
Videojet 3140/3340/3640/3 Installation
To Next Page
Loading...