NOTICE
To avoid condensation wait one hour before starting the system if the system was
brought from a cold to a warm environment.
Make sure that there is no condensed water in the system.
The venting slots of the supply unit and of the marking unit must not be covered.
Make sure that there is sufficient air supply (see also section "Cooling").
Setting Up
NOTICE
During setup, ensure there is free access to work space as well as free space
around the cooling and ventilating components.
Also ensure that the connecting cables and the exhaust hose are optimally instal-
led (protected).
Supply Unit
Marking Unit (applies to 10/30/60 W)
Mounting
For proper mounting there are metric holes in the bottom plate of the laser head
as well as in the bottom plate of the supply unit.
See Drawings [} 91].
09/17 - Index: AD [EN]
21
Videojet 3140/3340/3640/3 Installation
To Next Page