Chapter 2: System Setup and Configuration
34
Violin 6000 Series Memory Array Installation Guide
535-0045-00 Rev 02
The command displays text similar to the following:
All of the wizard steps are shown below, with the valid responses explained. Default values are
shown in brackets.
• At the command prompt, type the host name that will be used for the system.
• Press Enter to leave the administrator password empty or type a password to be used.
• Type “no” to use a static IP address, which is recommended. Type “yes” to use DHCP to
configure the public interfaces on this system. If you type “yes”, the system will attempt to
contact a DHCP server to obtain an IP address, default route, DNS servers and domain name.
• Type the Netmask value for the public interface provided by the network administrator. You
can also enter the value as a mask length after a slash, for example, “/24”.
• Type the Default Gateway IP address for the local subnet obtained from the network
administrator.
Violin Memory Array Configuration Wizard
This wizard will prompt you for the following items. Make sure you have
all of the following information below before starting:
Hostname
* Four host IP addresses (within the same subnet)
* Two management IP addresses (with netmask - if different from above)
* DNS server IP address and domain name
* Default Gateway
NTP server and time zone
Email hub and port for auto support feature (if callhome.vmem.com
cannot be directly reached)
* = not required if using DHCP.
Press '?' for help, Ctrl+B to go back to the previous step.
Default value is in square brackets: press Enter to accept it.
Press Ctrl+R to clear default to enter empty string.
Press Ctrl+C to jump to the end of the wizard at any time.█
Step 1: Hostname? [hostname of machine]█
Step 2: Admin password (Enter to leave unchanged)?█
Step 3: Use DHCP for all eth1 public interfaces? [no]█
Step 4: Netmask? [255.255.255.0]█
Step 5: Default gateway? [0.0.0.0]█
To Next Page
Loading...
