Violin Memory 6000 Series - Page 39

Completing the Configuration Wizard
535-0045-00 Rev 02
Violin 6000 Series Memory Array Installation Guide 35
• Type the IP address of the DNS server (that the system should use to resolve hostnames into
IP addresses) obtained from the network administrator.
• Type the DNS domain name in which the system resides (obtained from the network
administrator). For example, if the fully qualified host name is system1.example.com, you
would enter “example.com”.
• Type the IP address to be used for the Memory Gateway management IP address (obtained
from the network administrator).
• Type the IP address to be used for the Memory Gateway management netmask (obtained
from the network administrator).
• Type the IP address to be used for the ACM management IP address (obtained from the
network administrator).
• Type the IP address to be used for the ACM management netmask (obtained from the network
administrator).
• Type the IP address to be used for Memory Gateway A (mg-a) (obtained from the network
administrator).
• Type the IP address to be used for Memory Gateway B (mg-b) (obtained from the network
administrator).
• Type the IP address to be used for Array Controller Module A (acm-a) (obtained from the
network administrator).
Step 6: Primary DNS server? [0.0.0.0]█
Step 7: Domain name? []█
Step 8: Memory Gateway (MG) management IP address? [0.0.0.0]█
Step 9: Memory Gateway (MG) management IP netmask? [0.0.0.0]█
Step 10: ACM management IP address? [0.0.0.0]█
Step 11: ACM management IP netmask? [0.0.0.0]█
Step 12: Memory Gateway A (mg-a) host IP? [0.0.0.0]█
Step 13: Memory Gateway B (mg-b) host IP? [0.0.0.0]█
Step 14: Array Controller Module A (acm-a) host IP? [0.0.0.0]█
Step 15: Array Controller Module B (acm-b) host IP? [0.0.0.0]█