Violin Memory 6000 Series - Page 40

Chapter 2: System Setup and Configuration
36
Violin 6000 Series Memory Array Installation Guide 535-0045-00 Rev 02
• Type the IP address to be used for Array Controller Module B (acm-b) (obtained from the
network administrator).
• Press Enter to start setting the time zone, or type “no” to use an NTP server (Step 17). If you
choose “yes”, enter the Country, Zone and Sub-zones to use. If you are unsure of the proper
responses, type “?” to display a list of choices.
• Type the IP address(es) of the NTP server(s) to use (separated by commas if more than one is
used).
• Type the e-mail addresses of those who should receive an e-mail when an alert message is
sent from the Memory Array. Separate multiple e-mail addresses with a comma.
• Press Enter to use the default mailhub for the Call Home feature (notifications and autosupport
e-mails).
• Press Enter to use the default mailhub port.
• Press Enter to enable autosupport e-mails and log uploads to be delivered to Violin Memory.
Type “no” to disable delivery.
Note: It is highly recommended that you enable this feature so that Violin Memory Customer
Support is aware of any issues that arise and can promptly assist with a resolution.
Once you have entered the necessary information, all of the values that will be used are displayed
for confirmation. It is recommended that you review each answer to ensure that you entered all of
the appropriate values accurately, and then make changes if necessary.
To change an answer, type the step number and then change the information. Once the answers
are finished, press Enter to save the settings and exit the initial configuration.
Step 16: Set clock timezone? [yes]█
Step 17: NTP server name(s)? []█
Step 18: E-mail notification recipient(s)? [callhome@vmem.com]█
Step 19: E-mail mailhub? [callhome.vmem.com]█
Step 20: E-mail mailhub port? [25]█
Step 21: Enable Violin support? [yes]█