100 Redial
XTS-IP / XTSc-IP Station User Guide March 2007
Redial a Saved Number
To dial a number that was saved for redial, either:
Press the SPEED button, then press the [] key.
-or-
Use the Soft Key’s SNR option when in an idle condition. The saved
number is automatically dialed.
Repeat Redial
When placing a CO call and a Busy or No Answer is received:
1. Press the preprogrammed RPT REDIAL flexible button [643]. You will
receive an LCD prompt for a timer value.
2. Enter a valid number (006-999 seconds) for the Repeat Redial Timer.
The default value is 060 (one minute). A confirmation tone will
sound when you go on-hook. The flexible button LED will be lit
steady.
When the timer expires, you will receive a signal via a CO line
queue indication on the RPT REDIAL flexible button.
During the Queue Call Back, the LCD display will indicate that
this is a Redial Call Back.
Once the line queue is answered, the LCD will indicate an
outgoing CO line.
To activate a redial:
Press the preprogrammed REDIAL flexible button,
-or-
Press the ON/OFF button (SPEAKER button on IP Phone),
-or-
Lift the handset, line will be seized and number is dialed. If you
receive a busy/no answer, repeat the step to activate another redial.
ENTER RPT REDIAL TIMER:
XXX 006-999
To Next Page
Loading...
