26 Attendant Features
XTS-IP / XTSc-IP Station User Guide March 2007
7. Press HOLD, then use [] or [#] to scroll to next entry.
-or-
Hang up to end programming.
Attendant Disable Outgoing CO Line
The first Attendant can disable CO lines to prevent outgoing access to
those lines.
To disable CO Lines:
1. Lift the handset, or press the ON/OFF button (SPEAKER button on IP
Phone).
2. Dial [602] on the dial pad. A confirmation tone will sound.
3. Press the line button(s) of the CO Line(s) to disable. The CO Line
button(s) LED flashes; a confirmation tone sounds.
To reactivate the CO Line(s):
Repeat Steps 1-3 to disable this feature.
Attendant Override
When Attendant Override is enabled, Attendant stations may override
or call stations that are busy or in Do Not Disturb.
To call a station busy on a CO call:
Press the preprogrammed ATTN OVERRIDE button [601]. Three short
tone bursts are presented to the called party.
After five (5) seconds, the station’s CO line is automatically placed
on hold and the Attendant is cut-through.
To call a station in Do Not Disturb mode:
Press the preprogrammed ATTN OVERRIDE button. The station is
signaled with a Camp On tone.
To Next Page
Loading...
