36 Call Forward
XTS-IP / XTSc-IP Station User Guide March 2007
Call Forward - Follow Me
The Follow Me feature lets a user who is away from their station,
activate/deactivate call forwarding from another station in the system.
This lets the user forward their calls to their current location or into
Voice Mail, ACD/UCD, Hunt Group, any other station in the system, or to
an off-net location. When this call forward is activated, all calls
presented to the forwarded station forward to the destination station
immediately.
To activate Follow Me Call Forwarding:
1. Lift handset or press ON/OFF button (SPEAKER button on IP Phone).
2. Dial the Follow Me Forward code [642] on the dial pad.
3. Dial station number of the station from which forwarding is desired.
4. Dial the appropriate forwarding condition code.
[6] = All Calls [8] = Busy[
] = Off-Net
[7] = No Answer [9] = Busy/No Answer
5. Dial the three- or four-digit destination number where calls are to
be forwarded (Station, Voice Mail, ACD/UCD, Hunt Group, or speed
bin (only for off-net)).
6. Replace handset or press ON/OFF button (SPEAKER button on IP
Phone).
To remove Follow Me Call Forwarding:
1. Lift the handset or press the ON/OFF button (SPEAKER button on IP
Phone).
2. Dial the Follow Me Forward code [642] on the dial pad.
3. Dial station number of station that forwarding is to be cancelled.
4. Dial [6] (regardless of the forward condition).
5. Redial the same station number. Confirmation tone sounds and
FWD LED extinguishes.
To establish Follow Me Call Forwarding (off-site location):
1. Dial into the system on a DISA or TIE trunk. Enter the DISA access
code, if applicable.
2. Dial the Follow Me Forward code [642] on the dial pad.
To Next Page
Loading...
