Call Forward 35
XTS-IP / XTSc-IP Station User Guide March 2007
To remove Off-Net Call Forwarding:
1. Lift the handset or press ON/OFF (SPEAKER button on IP Phone).
2. Press the FWD button or dial either [640] or [662]. A confirmation
tone sounds and the FWD LED extinguishes.
SINGLE LINE TELEPHONE
The SLT operation uses the same procedures as used in Digital
Telephone operation described above, except there is no FWD
button. The user must use the 640 feature code to activate and 662
to clear.
Call Forward - External (Off-Net) Redirect
This feature allows a user who receives a call, that has been forwarded
off-net via PRI, to redirect that call back to a destination within the
XTS-IP / XTSc-IP system.
Feature operation sequence:
Off-net forward is set.
Call is received from CO on XTSc-IP trunk (can be any type of CO
trunk).
Call is sent to a PRI trunk and forwarded to an off-net destination,
e.g., a cell phone.
Cell phone user answers the call.
Cell phone user dials [*] + [*] + destination number within the
XTS-IP / XTSc-IP to which the call is redirected.
While in the dialing state, the cell phone user does not receive dial
tone, both parties are still connected, the original caller hears DTMF
tones as the cell phone user dials. At the conclusion of dialing the
destination number, the calling party is connected to the new
destination and the cell phone user is disconnected from the call.
If the off-net forward is made on a trunk other than PRI, the Redirect
feature will not work.
To Next Page
Loading...
