106 Speed Dial
XTS-IP / XTSc-IP Station User Guide March 2007
To store speed dial numbers:
1. Press the SPEED button once.
2. Press an OUTSIDE LINE button or the POOL button.
-or-
Select an outside line by pressing the SPEED button again.
3. Dial the speed bin location.
4. Dial desired telephone number and include these special codes:
5. Press the SPEED button.
6. Replace the handset to end the speed bin programming.
To program multiple speed numbers:
1. Press the SPEED button twice to conclude programming a number.
2. Enter the next speed number bin to program.
If the station has no line appearance for the line programmed into
the speed bin, that line comes up under the LOOP button or POOL
button when accessed.
To erase an existing speed bin:
1. Press the SPEED button twice.
2. Dial the speed bin location.
3. Press the SPEED button again. A confirmation tone will sound.
TRANS -- Initiates a Pulse-To-Tone switchover.
HOLD -- Inserts a Pause.
FLASH -- Inserts a Flash into the speed number.
TRANS -- When used as first entry in speed bin, this inserts a non-
display character causing numbers stored in the bin not to
appear on a digital phone’s display when bin is accessed.
To Next Page
Loading...
