S80645A
Safety when servicing
General 147
General
WARNING!
Breaking these rules may lead to an accident, serious
injuries.
•
Read all plates and decals on the machine and in the Opera-
tor's Manual before carrying out service on the machine. Each
of the instructions contain important information about the han-
dling and service of the machine.
No work may be carried out on the machine, unless the person
doing so has acquired the right knowledge and training to do
so.
Service work, which is not carried out in the correct way, is dan-
gerous.
Make sure you have sufficient knowledge, correct information,
correct tools and correct equipment to carry out the service in
a correct way.
Repair or change broken tools and equipment.
Avoid spillage when emptying/draining oil or fuel. Where fluid
cannot be drained directly into a vessel, use a pump or connect
a hose for safe handling. Oil, which is spilled onto the ground,
will harm the environment and also cause a fire.
Used oil and other liquids should always be taken care of by a
disposal firm authorized for this purpose.
A machine which is used within a contaminated area (polluted
environment and/or insanitary area) should be equipped in a
special way. In addition to this, special safety regulations apply
when servicing such a machine.
Check that all slip protections are firmly fixed. If they are not,
they should be fastened or replaced,
When using high pressure for washing, the jet should not be di-
rected at anti-slip surfaces which are glued on.
Make sure that stepping surfaces, service areas, handholds
and anti-slip surfaces are free from oil, diesel fuel, dirt or ice
and that they are replaced if they are damaged or missing.
Never step on parts of the machine which are not prepared
or intended for this.
To Next Page
Loading...
