Operating instructions
Changing bucket 109
Changing bucket
A
B
Remove bucket
WARNING!
While striking the bucket pin with a hammer, metal chips
may fly into your eyes.
Always wear goggles, safety helmets and gloves while
working.
Block the removed bucket to stabilize it.
S80250A
S80248A
1 Lower the bucket lightly onto the ground.
2 Remove lock bolt (A) and nut (B) of each pin
3 Remove pin (C and 0), then remove the bucket.
IMPORTANT
Keep the pins clean and do not damage 0-ring (E).
D
c
Installing bucket
A
WARNING!
Do not insert your fingers into the pin bores to check
alignment, a serious accident could occur.
1 Align the arm to the bucket holes and link holes.
2 Apply grease to the holes.
3 Put 0-rings (E) at the holes for the arm.
4 Insert pins (C and D).
5 Install lock bolt (A) and nut (B) of each pin.
IMPORTANT
Leave a clearance of minimum 2 mm between pin and nut,
and grease the pin.
To Next Page
Loading...
