Specifications
Recom mended lubricants 211
Specifications
Recommended lubricants
System
Oil grade
°C
°F
Recommended viscosity at varying
ambient temperature
-30
-22
-20
-10
0
+10 +20
+30
+40
-4
+14
+32
+50
+68
+86
+104
I
I
I
I
I
+50
+122
Engine
Engine oil
VDS-3 or
Global DHD-1 + VDS-2 or
ACEA-E5 + VDS-2 or
API CH-4 + VDS-2
SAE5W-30
SAE 10W30
*SAE 15W-40
SAE 30
SAE 40
Track reduction
gearbox
Gear oil (with EP additive)
API GL4 or GL5
*SAE 90
SAE 140
Swing gearbox
Gear oil (with EP additive)
API GL4 or GL5
*SAE 90
SAE 140
Swing ring gear
(Bath and Ball)
Grease
Multi purpose EP-grease NLGI 2
Hydraulic system
Hydraulic oil (Anti-wear
hydraulic oil with high vis-
cosity index 160 or more)
ISO VG32 HV
ISO VG46 HV
ISO VG68 HV
Bio oil (based on syn-
thetic ester)
Bio oil VG32
Bio oil VG46
Pin and bushing
Grease (Multi purpose EP-
grease NLGI 2)
*lSOL..XBCFB2
Fuel
Diesel fuel
ASTM
D975 No.1
*ASTM D975 No.2
Cooling system
Coolant
Use the same coolant as filled before, see page 174.
Air conditioner
system
Refrigerant
HFC R134a
°C
°F
I
I I
I
-30
-20
-10
0
+10 +20
+30
+40
+50
-22
-4
+14
+32
+50
+68
+86
+104 +122
* : Installed at factory.
NOTE! When starting the engine in an ambient temperature of lower than 0°C, be sure to use engine oil
of SAE lOW, SAE 10W-30 and SAE 15W-40, even though the ambient temperature goes up to 10°C more
or less in the day time.
NOTE! The fuel should at least meet the legal requirement, and national and international standards for
marketed fuels, for example: EN590 (with nationally adapted temperature requirements), ASTM D975 No
1D and 2D, JIS KK 2204.
NOTE! Sulphure content : According to current legal requirements (the sulphur content should not ex-
ceed 0.3 percent by weight)
The content of Volvo coolant must not be less than 40% of the total mixture.
To Next Page
