Operating instructions
126
After operating
After operating
WARNING!
When you are entering and leaving the machine, always
face the machine and use the steps or hand holds to avoid
slipping. Always use the three-point stance, i.e. two hands
and one foot or two feet and one hand when climbing up
onto or descending from the machine, Do not jump!
Stopping machine
IMPORTANT
Select level ground to park the machine.
1 Put the left and right operating levers to neutral position.
2 Turn the engine speed control switch to low idle speed posi-
tion.
3 Lower the bucket to the ground, keeping the bottom of the
bucket parallel to the ground.
4 Move the safety locking lever down to lock the hydraulic
system securely, See Safety locking system on page 81.
Stopping engine
IMPORTANT
Run the engine at low idle speed for a few minutes before
stopping it to safeguard lubrication of the turbocharger.
1 Turn the starting switch to stop
(0)
position
NOTE:
If the machine is to be left for any length of time, the current
should be turned OFF with the battery master switch.
See Long-term parking on
page 127.
To Next Page
Loading...
