Service and maintenance
Engine 165
Replacing engine oil filter
Replace the oil filters each time the oil is changed, i.e.
every 500
hours. CH-4 class: every 500 hours, if lower than CG-4 class:
every 250 hours. See
Checking engine oil level
on page 163.
The oil filter is of the disposable type, i e. it cannot be cleaned,
but should be replaced as one unit.
Removing
1 Loosen and open engine oil filter cap (B)
2 Pull a used filter element out of the engine oil filter housing (A)
— Use a suitable tool for removing oil filter element.
Installing
3 Put a new filter element into the engine oil filter housing (A).
4 Tighten the engine oil filter cap (B) on the engine oil filter hous-
ing (A).
— Tightening torque is written on the engine oil filter cap (B)
After installing
5 Start up the engine and check that the gaskets are sealed. If it
does not, remove the filter and check the sealing surface.
NOTE:
Usually it does not help to further tighten the filter.
IMPORTANT
After replacing oil filters, the engine must run at low idling
for at least one minute. It is important that the filters are filled
with oil before it is installed. This is to ensure lubrication
immediately after starting.
A
WARNING!
Take care of waste oil/liquids in an environmentally safe
way!
Valve clearance
Valve clearance, adjusting
Check the valve clearance every 1500 hours.
The work should be carried out by an authorized Volvo dealer
workshop.
To Next Page
Loading...
