Operating instructions
76 Safety and responsibility
VOE 2134355130
Never operate close to a high tension
power line
You can receive an electric shock if the machine approaches close
to a high tension power line. Physical contact is not necessary to
draw current from the power line!
If working near a high tension power line, prohibit everyone from
approaching the machine.
Contact the electricity supply company prior to working near over-
head power lines.
For safety reasons, maintain the following minimum distance be-
tween the machine and the power line.
If the attachment comes into contact with the power line, stay in the
cab, and if the machine remains functional, try to break the circuit
by moving the attachment away from the power line.
Permissible depth of water
Permissible working depth in water is the center of upper rollers.
Do not fully submerge the upper rollers.
Upon leaving the water, make sure all the grease is replenished in
the areas affected by the water, e.g. bucket pin etc., remove the
old grease completely regardless of the maintenance period. Also
check the oil in the travel drive for contamination, and if necessary,
replace it.
Voltage Mininum distance to power line
0~1KV 2m(7ft)
1 ~ 55 KV 4 m (13 ft)
55 ~ 500 KV 6 m (20 ft)
WARNING!
When traveling out of water, If the rear of the upper body is
under water, the engine fan may be damaged. Be careful in
this situation.
1
2
Upper roller
Water level
S82201
S82140
S82141
2
1
To Next Page
Loading...
